Wlan Antenna Type - Siemens SIMATIC NET Configuration Manual

6.1.5.16

wlan antenna type

Description
With this command, you specify which antenna type is connected to the relevant antenna
connector.
Requirement
You are in the Interface Configuration mode of the WLAN interface.
The command prompt is as follows:
cli (config-if-wlan-0-X)#
Syntax
Call up the command with the following parameters:
wlan antenna type {show-types | <index(1)> <antenna-index>}
The parameters have the following meaning:
Parameter
show-types
index
antenna-index
Result
The antenna type is specified.
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 10/2015, C79000-G8976-C351-05
Description
Shows a list of supported antennas
with the corresponding antenna index.
Antenna connector
Antenna index
Network structures
Range of values / note
--
1
Enter the required antenna index.
You can obtain an overview of the an-
tenna indexes available on the
SCALANCE W700 device with the
antenna type show-types
6.1 WLAN
wlan
command.
169