Ipv6 Neighbor Discovery Commands; Create Ipv6 Neighbor_Cache - D-Link DES-1210-52/ME Cli Reference Manual

IPV6 NEIGHBOR DISCOVERY COMMANDS

The IPv6 Neighbor Discovery commands in the Command Line Interface (CLI) are listed (along with the
appropriate parameters) in the following table.
Command
create ipv6
neighbor_cache
delete ipv6
neighbor_cache
show ipv6
neighbor_cache
show ipv6 nd
config ipv6 nd ns ipif
System
create ipv6route default
delete ipv6route default
show ipv6route
enable
ipif_ipv6_link_local_auto
System
disable
ipif_ipv6_link_local_auto
System
Each command is listed in detail, as follows:

create ipv6 neighbor_cache

Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To create a static neighbor cache entry on the interface System, with an IPv6 address of 3ffc::1 and a MAC address
of 00:01:02:03:04:05:
DES-1210-52/ME L2 Metro Ethernet Switch CLI Reference Guide
Parameter
ipif System <ipv6_addr> <mac_addr>
[ipif system | all] [<ipv6_addr> | static | dynamic | all]
[<ipif_name 12> | all] [ipv6address <ipv6_addr> | static | dynamic | all]
retrans_time <integer 1-3600>
<ipv6addr>
Used to add a static neighbor on an IPv6 interface.
create ipv6 neighbor_cache ipif System <ipv6_addr>
<mac_addr>
This create ipv6 neighbor_cache command is used to add a static
neighbor on an IPv6 interface.
<ipv6_addr> –The IPv6 address of the neighbor.
<mac_addr> –The MAC address of the neighbor.
Only Administrator or operator-level users can issue this command.
338
47