Create Filter Dhcpv6_Server Permit_Entry - D-Link DES-1210-52/ME Cli Reference Manual

Description
Parameters
Restrictions
Example usage:
To display the DHCP server screening information on the switch:
DES-1210-52/ME:5# show dhcp_server screening
Command: show dhcp_server screening
Illegal Server Log Suppress Duration : 5 Minutes
DHCP server screening :
Port Admin state
---- -----------
1
2
3
4
5
6
7
8
9
10
11
12
13
14
CTRL+C ESC q Quit SPACE n Next Page ENTER Next Entry a ALL

create filter dhcpv6_server permit_entry

Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
DES-1210-52/ME L2 Metro Ethernet Switch CLI Reference Guide
The show dhcp_server screening command is used to display
current DHCP server screening information on the switch.
None.
None.
disabled
disabled
disabled
disabled
disabled
disabled
disabled
disabled
disabled
disabled
disabled
disabled
disabled
disabled
DHCPv6 server packets except those that have been IP/client MAC
bound will be filtered. This command is used to create a permit
entry. The specific DHCPv6 server packets, with the source IPv6
address, will be forwarded on t he specified ports.
create filter dhcpv6_server permit_entry <ipv6addr> ports
[<portlist> | all]
The create filter dhcpv6_server permit_entry command is used to
create a permit entry. The specific DHCPv6 server packets, with the
source IPv6 address, will be forwarded on the specified ports.
<ipv6addr> – The IPv6 address of the DHCPv6 server to be filtered.
ports [<portlist> | all] – The ports or all ports to which the DHCPv6
filter will be applied.
Only administrator or operate-level users can issue this command.
60