Config Ethernet_Oam Ports - D-Link DES-1210-52/ME Cli Reference Manual

L2 managed metro ethernet switch
Hide thumbs Also See for DES-1210-52/ME:
Table of Contents

Advertisement

Restrictions
Example usage:
To configure ports 1 to 3 to OAM mode to active:

config ethernet_oam ports

Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To configure ports 1 to 3 to OAM critical link event dying GASP state to be enabled:
config ethernet_oam ports
Purpose
Syntax
Description
Parameters
DES-1210-52/ME L2 Metro Ethernet Switch CLI Reference Guide
state [enable | disable] – Specifies the state to be enabled or
disabled.
Only administrator or operator-level users can issue this command.
DES-1210-52/ME:5# config ethernet_oam ports 1-3 mode active
Command: config ethernet_oam ports 1-3 mode active
Success.
DES-1210-52/ME:5#
Used to configure Ethernet OAM critical link event.
config ethernet_oam ports [<portlist> | all] critical_link_event
[critical_event | dying_gasp] notify_state [enable | disable]
The config ethernet_oam ports command is used to configure
ports for critical link event of Ethernet OAM.
<portlist> − Specifies a port or range of ports to be configured.
all – Entering this command will set all ports on the system.
critical_link_event [critical_event | dying_gasp] – Specifies the
critical link event is critical event or dying GASP.
notify_state [enable | disable] – Specifies to enable or disable the
event notification. The default state is enabled.
Only administrator or operator-level users can issue this command.
DES-1210-52/ME:5# config ethernet_oam ports 1-3 critical_link_event
dying_gasp notify_state enable
Command:
config
dying_gasp notify_state enable
Success.
DES-1210-52/ME:5#
Used to configure Ethernet OAM link monitor.
config ethernet_oam ports [<portlist> | all] link_monitor
[error_frame | error_frame_period | error_frame_seconds |
error_symbol] notify_state [enable | disable] {threshold
<integer 1-4294967295> | window <integer 1000-60000>}
The config ethernet_oam ports command is used to configure
ports link monitor of Ethernet OAM.
<portlist> − Specifies a port or range of ports to be configured.
ethernet_oam
ports
247
1-3
critical_link_event

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents