Dhcp Relay Commands - D-Link DES-1210-52/ME Cli Reference Manual

The DHCP Relay commands in the Command Line Interface (CLI) are listed (along with the appropriate
parameters) in the following table.
Command
enable dhcp_relay
disable dhcp_relay
config dhcp_relay port
config dhcp_relay add
ipif System
config dhcp_relay
delete ipif System
config dhcp_relay hops
config dhcp_relay vlan
config dhcp_relay
option_82
config dhcp_relay
port_option_82
show dhcp_relay
port_option_82
show dhcp_relay
enable
dhcp_local_relay
disable
dhcp_local_relay
config dhcp_local_relay
port
config dhcp_local_relay
vlan
show dhcp_local_relay
enable dhcpv6_relay
disable dhcpv6_relay
show dhcpv6_relay
config dhcpv6_relay
config dhcpv6_relay
hop_count
config dhcpv6_relay
option_37
DES-1210-52/ME L2 Metro Ethernet Switch CLI Reference Guide
Parameter
<portlist> state [enable | disable]
<ipaddr>
<ipaddr>
<value 1-16>
[<vlan_name 32> | vlanid <vidlist>] state [enable | disable]
[check [enable | disable] | policy [drop | keep | replace] | remote_id [default |
user_define <desc 32>] | state [enable | disable] | circuit_id [default | user_define
<desc 32>] ]
{<portlist>} [ circuit_id | remote_id ] vendor3 <desc 32>
{<portlist>}
{ipif}
port <portlist> state [enable | disable]
[<vlan_name 32> | vlanid <vidlist>] state [enable | disable]
{ipif System | option_38 ports <portlist>}
[add | delete] ipif system <ip6_addr>
<value 1-32>
[check | state] [enable | disable] | remote_id [default | user_define <string 128> |
cid_with_user_define <string 128>]]

DHCP RELAY COMMANDS

114
16