Config Filter Dhcp_Server Log State; Show Filter Dhcp_Server; Show Dhcp_Server Screening - D-Link DES-1210-52/ME Cli Reference Manual

config filter dhcp_server log state

Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To enable the Filter DHCP Server log state:
DES-1210-52/ME:5# config filter dhcp_server log state enable
Command: config filter dhcp_server log state enable
Success.
DES-1210-52/ME:5#

show filter dhcp_server

Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To display the DHCP server filter list created on the switch:
DES-1210-52/ME:5# show filter dhcp_server
Command: show filter dhcp_server
Enabled ports :
Illegal Server Log Suppress Duration : 5 Minutes
Permit DHCP Server/Client Table:
Server IP Address Client MAC Address Ports
-------------------------- ----------------------------- ----------------
10.1.1.1
DES-1210-52/ME:5#

show dhcp_server screening

Purpose
Syntax
DES-1210-52/ME L2 Metro Ethernet Switch CLI Reference Guide
To enable or disable the DHCP server log on the Switch.
config filter dhcp_server log state [enable | disable]
The config filter dhcp_server log state command is used to
enable or disable the Filter DHCP server log state.
state [enable | disable] – Specifies that the log for the Filter DHCP
server will be enabled or disabled.
Only administrator or operate-level users can issue this command.
Used to display current DHCP server/client filter list created on the
switch.
show filter dhcp_server
The show filter dhcp_server command is used to display DHCP
server/client filter list created on the switch.
None.
None.
00-00-00-00-00-01
Used to display current DHCP server screening information on the
switch.
show dhcp_server screening
6-8
59