Config Traffic Control Auto_Recover_Time; Show Traffic Control - D-Link DES-1210-52/ME Cli Reference Manual

Restrictions
Example usage:
To configure traffic control and enable broadcast storm control system wide:
DES-1210-52/ME:5# config traffic control all multicast enable unicast disable
broadcast enable threshold 64
Command: config traffic control all multicast enable unicast disable broadcast e
nable threshold 64
*Note: Setting count down for drop mode port was ignored.
Success.
DES-1210-52/ME:5#

config traffic control auto_recover_time

Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To configure the auto recover time to 100:
DES-1210-52/ME:5# config traffic control auto_recover_time 100
Command: config traffic control auto_recover_time 100
Success.
DES-1210-52/ME:5#

show traffic control

Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To display traffic control setting for ports 1-3:
DES-1210-52/ME:5# show traffic control 1-3
DES-1210-52/ME L2 Metro Ethernet Switch CLI Reference Guide
Only administrator or operator-level users can issue this command.
To configure the traffic auto recover time that allowed for a port to
recover from shutdown forever status.
config traffic control auto_recover_time [0 | <min 1-65535>]
config
The
configures.
[0 | <min 1-65535>] – Specifies the automatic recovery time to be
used. The value must be between 1 and 65535 minutes. 0 means
'no recovery mode'.
Only administrator or operator-level users can issue this command.
To display current traffic control settings.
show traffic control {<portlist>}
The show traffic control command displays the current storm traffic
control configuration on the Switch.
<portlist> - A port or range of ports whose settings are to be
displayed.
None.
traffic control
auto_recover_time
176
command