Config Stp Version; Config Stp Fbpdu - D-Link DES-1210-52/ME Cli Reference Manual

Restrictions
Example usage:
To configure STP with path cost 19 and state enable for ports 1-3:

config stp version

Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To set the Switch globally for the Multiple Spanning Tree Protocol (MSTP):

config stp fbpdu

Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To set the Switch globally for the Spanning Tree Protocol (STP) fbpdu enable:
DES-1210-52/ME L2 Metro Ethernet Switch CLI Reference Guide
Only administrator or operator-level users can issue this command.
DES-1210-52/ME:5# config stp ports 1-3 externalcost 19 state enable
Command: config stp ports 1-3 externalcost 19 state enable
Success.
DES-1210-52/ME:5#
To globally set the version of STP on the Switch.
config stp version [mstp | rstp | stp]
The config stp version command sets the version of the spanning
tree to be implemented on the Switch.
mstp – Sets the Multiple Spanning Tree Protocol (MSTP) globally on
the Switch.
rstp – Sets the Rapid Spanning Tree Protocol (RSTP) globally on
the Switch.
stp – Sets the Spanning Tree Protocol (STP) globally on the Switch.
Only administrator-level users can issue this command.
DES-1210-52/ME:5# config stp version mstp
Command: config stp version mstp
Success.
DES-1210-52/ME:5#
To globally set the fbpdu of STP on the Switch.
config stp fbpdu [enable | disable]
The config stp fbpdu command allows the forwarding of STP
BPDU packets from other network devices when STP is disabled on
the Switch.
None.
Only administrator-level users can issue this command.
DES-1210-52/ME:5# config stp fbpdu enable
Command: config stp fbpdu enable
Success.
DES-1210-52/ME:5#
156