HP 3600 v2 series Configuration Manual page 273
Hide thumbs
Also See for 3600 v2 series:
- Command reference manual (510 pages) ,
- Configuration manual (449 pages) ,
- Security configuration manual (398 pages)
Table of Contents
Advertisement
Figure 99 Network diagram
Configuration procedure
Configure the IPv6 addresses for all VLAN interfaces. (Details not shown)
1.
Configure IPv6 static routes.
2.
# Configure a default IPv6 static route on Switch A.
<SwitchA> system-view
[SwitchA] ipv6
[SwitchA] ipv6 route-static :: 0 4::2
# Configure two IPv6 static routes on Switch B.
<SwitchB> system-view
[SwitchB] ipv6
[SwitchB] ipv6 route-static 1:: 64 4::1
[SwitchB] ipv6 route-static 3:: 64 5::1
# Configure a default IPv6 static route on Switch C.
<SwitchC> system-view
[SwitchC] ipv6
[SwitchC] ipv6 route-static :: 0 5::2
Configure the IPv6 addresses and gateways for hosts.
3.
Configure the IPv6 addresses for all the hosts based on the network diagram, configure the default
gateway of Host A as 1::1, Host B as 2::1, and Host C as 3::1.
Verify the configuration.
4.
# Display the IPv6 routing table of Switch A.
[SwitchA] display ipv6 routing-table
Routing Table :
Destinations : 5
Destination
NextHop
Interface
Destination
NextHop
: ::
: 4::2
: Vlan-interface200
: ::1/128
: ::1
Routes : 5
261
Protocol
: Static
Preference
: 60
Cost
: 0
Protocol
: Direct
Preference
: 0
- Quick Links:
- Ip Routing Basics
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
