Routing Policy Configuration Examples; Applying A Routing Policy To Ipv4 Route Redistribution - HP 3600 v2 series Configuration Manual

To do...
Display routing policy information
Clear IPv4 prefix list statistics
Clear IPv6 prefix list statistics

Routing policy configuration examples

Applying a routing policy to IPv4 route redistribution

Network requirements
As shown in
Switch C using IS-IS.
On Switch B, enable route redistribution from IS-IS to OSPF, and apply a routing policy to set the cost of
route 172.17.1.0/24 to 100 and the tag of route 172.17.2.0/24 to 20.
Figure 119 Network diagram
Configuration procedure
Specify IP addresses for interfaces. (Details not shown)
1.
Configure IS-IS.
2.
# Configure Switch C.
<SwitchC> system-view
[SwitchC] isis
[SwitchC-isis-1] is-level level-2
[SwitchC-isis-1] network-entity 10.0000.0000.0001.00
[SwitchC-isis-1] quit
[SwitchC] interface vlan-interface 200
[SwitchC-Vlan-interface200] isis enable
[SwitchC-Vlan-interface200] quit
[SwitchC] interface vlan-interface 201
[SwitchC-Vlan-interface201] isis enable
Use the command...
display route-policy [ route-policy-name ] [ | { begin
| exclude | include } regular-expression ]
reset ip ip-prefix [ ip-prefix-name ]
reset ip ipv6-prefix [ ipv6-prefix-name ]
Figure 1 19, Switch B exchanges routing information with Switch A using OSPF, and with
370
Remarks
Available in user
view