Configuring Ipv6 Bgp Community - HP 3600 v2 series Configuration Manual

To do...
Specify the AS number of an IPv6
peer
Add the IPv6 peer into the peer
group
NOTE:
When creating a mixed eBGP peer group, you must create a peer and specify its AS number that is
different from AS numbers of other peers; however, you cannot specify AS number for the eBGP peer
group.

Configuring IPv6 BGP community

Advertise community attribute to an IPv6 peer or peer group
Follow these steps to advertise community attribute to an IPv6 peer or peer group:
To do...
Enter system view
Enter BGP view
Enter IPv6 address family view
Advertise community attribute to an
IPv6 peer or peer group
Advertise extended community
attribute to an IPv6 peer or peer
group
Apply a routing policy to routes advertised to a peer or peer group
Follow these steps to apply a routing policy to routes advertised to a peer or peer group:
To do...
Enter system view
Enter BGP view
Enter IPv6 address family view
Apply a routing policy to routes
advertised to an IPv6 peer or peer
group
NOTE:
When configuring IPv6 BGP community, you must configure a routing policy to define the community
•
attribute, and apply the routing policy to route advertisement.
For routing policy configuration, see the chapter "Routing policy configuration."
•
Use the command...
peer ipv6-address as-number
as-number
peer ipv6-address group
ipv6-group-name
Use the command...
system-view
bgp as-number
ipv6-family
peer { ipv6-group-name |
ipv6-address }
advertise-community
peer { ipv6-group-name |
ipv6-address }
advertise-ext-community
Use the command...
system-view
bgp as-number
ipv6-family
peer { ipv6-group-name |
ipv6-address } route-policy
route-policy-name export
344
Remarks
Required
Not specified by default.
Required
Not added by default
Remarks
—
—
—
Required
Not advertised by default.
Required
Not advertised by default.
Remarks
—
—
—
Required
Not applied by default.