Configuring Ospf Frr - HP 3600 v2 series Configuration Manual

# Use the ACL to filter route 10.5.1.0/24.
[SwitchA] ospf 1
[SwitchA-ospf-1] filter-policy 2000 import
[SwitchA-ospf-1] quit
# Display the OSPF routing table of Switch A.
[SwitchA] display ip routing-table
Routing Tables: Public
Destinations : 10
Destination/Mask
3.1.1.0/24
3.1.2.0/24
10.1.1.0/24
10.1.1.1/32
10.2.1.0/24
10.2.1.1/32
10.3.1.0/24
10.4.1.0/24
127.0.0.0/8
127.0.0.1/32
The route destined for 10.5.1.1/24 is filtered out.

Configuring OSPF FRR

Network requirements
Switch S, Switch A, and Switch D belong to the same OSPF domain as illustrated in
OSPF FRR so that when the link between Switch S and Switch D fails, traffic can be switched to Link B
immediately.
Figure 47 Network diagram
Loop 0
1.1.1.1/32
Configuration procedure
Configure IP addresses for the interfaces on each switch and configure OSPF.
1.
Follow Figure 47
not shown)
Configure OSPF on the switches, ensuring that Switch S, Switch A, and Switch D can communicate with
each other at Layer 3. (Details not shown)
Proto Pre
O_ASE 150
O_ASE 150
Direct 0
Direct 0
Direct 0
Direct 0
OSPF 10
OSPF 10
Direct 0
Direct 0
Vlan-int200
13.13.13.1/24
Switch S
to configure the IP address and subnet mask of each interface on the switches. (Details
Routes : 10
Cost NextHop
1 10.2.1.2
1 10.2.1.2
0 10.1.1.1
0 127.0.0.1
0 10.2.1.1
0 127.0.0.1
4 10.1.1.2
13 10.2.1.2
0 127.0.0.1
0 127.0.0.1
Switch A
Link B
Link A
Vlan-int200
13.13.13.2/24
122
Interface
Vlan200
Vlan200
Vlan100
InLoop0
Vlan200
InLoop0
Vlan100
Vlan200
InLoop0
InLoop0
Figure 47. Configure
Loop 0
4.4.4.4/32
Switch D