HP 3600 v2 series Configuration Manual page 428

Figure 132 Network diagram
Configuration procedure
Configure VPN instances.
1.
# Create VPN instances on the MCE and PE 1, and bind the VPN instances with VLAN interfaces. For the
configuration procedure, see
Configure routing between the MCE and VPN sites.
2.
# Start an OSPF process on the devices in the two VPNs and advertise the subnets. (Details not shown)
# Configure OSPF on the MCE, and bind OSPF process 10 with VPN instance vpn1 to learn the routes
of VPN 1.
<MCE> system-view
[MCE] ospf router-id 10.214.10.3 10 vpn-instance vpn1
[MCE-ospf-10] area 0
[MCE-ospf-10-area-0.0.0.0] network 10.214.10.0 0.0.0.255
# Display the routing table of VPN 1 on the MCE.
[MCE-ospf-10-area-0.0.0.0] display ip routing-table vpn-instance vpn1
Routing Tables: vpn1
Destinations : 5
Destination/Mask
10.214.10.0/24
10.214.10.3/32
127.0.0.0/8
"Using OSPF to advertise VPN routes to the
Routes : 5
Proto Pre Cost
Direct 0 0
Direct 0 0
Direct 0 0
416
PE."
NextHop Interface
10.214.10.3 Vlan10
127.0.0.1 InLoop0
127.0.0.1 InLoop0