Configuration Prerequisites; Configuring The Ospfv3 Network Type For An Interface; Configuring An Nbma Or P2Mp Neighbor; Configuring Ospfv3 Routing Information Control - HP 3600 v2 series Configuration Manual

Configuration prerequisites

Before configuring OSPFv3 network types, complete the following tasks:
Configure IPv6 functions
•
Configure OSPFv3 basic functions
•

Configuring the OSPFv3 network type for an interface

Follow these steps to configure the OSPFv3 network type for an interface:
To do...
Enter system view
Enter interface view
Configure a network type for the
OSPFv3 interface

Configuring an NBMA or P2MP neighbor

For NBMA and P2MP interfaces (only when in unicast mode), specify the link-local IP addresses of their
neighbors because these interfaces cannot find neighbors through broadcasting hello packets. You can
also specify DR priorities for neighbors.
Follow these steps to configure an NBMA or P2MP (unicast) neighbor and its DR priority:
To do...
Enter system view
Enter interface view
Specify an NBMA or P2MP
(unicast) neighbor and its DR
priority

Configuring OSPFv3 routing information control

This section describes how to configure the control of OSPF routing information advertisement and
reception, and redistribution from other protocols.
Configuration prerequisites
Before configuring OSPFv3 routing information control, complete the following tasks:
Enable IPv6 packet forwarding
•
Configure OSPFv3 basic functions
•
Use the command...
system-view
interface interface-type
interface-number
ospfv3 network-type { broadcast |
nbma | p2mp [ non-broadcast ] |
p2p } [ instance instance-id ]
Use the command...
system-view
interface interface-type
interface-number
ospfv3 peer ipv6-address
[ dr-priority dr-priority ] [ instance
instance-id ]
286
Remarks
—
—
Optional
The network type of an interface
depends on the media type of the
interface.
Remarks
—
—
Required