Ipv4 Pbr Configuration Example (Using A Qos Policy) - HP 3600 v2 series Configuration Manual

[SwitchA-Vlan-interface20] ip address 1.1.3.1 255.255.255.0
Configure Switch B.
2.
# Configure a static route to subnet 10.1 10.0.0/24.
<SwitchB> system-view
[SwitchB] ip route-static 10.110.0.0 24 1.1.2.1
# Configure the IP address of VLAN-interface 10.
[SwitchB] interface vlan-interface 10
[SwitchB-Vlan-interface10] ip address 1.1.2.2 255.255.255.0
[SwitchB-Vlan-interface10] quit
Configure Switch C.
3.
# Configure a static route to subnet 10.1 10.0.0/24.
<SwitchC> system-view
[SwitchC] ip route-static 10.110.0.0 24 1.1.3.1
# Configure the IP address of VLAN-interface 20.
[SwitchC] interface vlan-interface 20
[SwitchC-Vlan-interface20] ip address 1.1.3.2 255.255.255.0
[SwitchC-Vlan-interface20] quit
Verification
Configure the IP address of Host A as 10.1 10.0.20/24, and the gateway as 10.1 10.0.10.
On Host A, telnet to Switch B (1.1.2.2) that is directly connected to Switch A. The operation succeeds.
On Host A, telnet to Switch C (1.1.3.2) that is directly connected to Switch A. The operation fails.
Ping Switch C from Host A. The operation succeeds.
Telnet uses TCP, and ping uses ICMP. The preceding results show that all TCP packets arriving on
VLAN-interface 1 1 of Switch A are forwarded to next hop 1.1.2.2, and other packets are forwarded via
VLAN-interface 20. The PBR configuration is effective.

IPv4 PBR configuration example (using a QoS policy)

Network requirements
As shown in
202.1.1.2.
Figure 124 Network diagram
Figure 124, redirect all packets received on Ethernet 1/0/1 of Switch A to the next hop
388