Configuration Prerequisites; Configuring Ipv6 Bgp Peer Group - HP 3600 v2 series Configuration Manual

Configuration prerequisites

Make peer nodes accessible to each other at the network layer
•
Enable BGP and configure a router ID.
•

Configuring IPv6 BGP peer group

Configuring an iBGP peer group
Follow these steps to configure an iBGP group:
To do...
Enter system view
Enter BGP view
Enter IPv6 address family view
Create an iBGP peer group
Add a peer into the group
Creating a pure eBGP peer group
Follow these steps to configure a pure eBGP group:
To do...
Enter system view
Enter BGP view
Enter IPv6 address family view
Create an eBGP peer group
Configure the AS number for the
peer group
Add an IPv6 peer into the peer
group
NOTE:
To create a pure eBGP peer group, specify an AS number for the peer group.
•
If a peer was added into an eBGP peer group, you cannot specify any AS number for the peer group.
•
Creating a mixed eBGP peer group
Follow these steps to create a mixed eBGP peer group:
To do...
Enter system view
Enter BGP view
Enter IPv6 address family view
Create an eBGP peer group
Use the command...
system-view
bgp as-number
ipv6-family
group ipv6-group-name [ internal ]
peer ipv6-address group
ipv6-group-name [ as-number
as-number ]
Use the command...
system-view
bgp as-number
ipv6-family
group ipv6-group-name external
peer ipv6-group-name as-number
as-number
peer ipv6-address group
ipv6-group-name
Use the command...
system-view
bgp as-number
ipv6-family
group ipv6-group-name external
343
Remarks
—
—
—
Required
Required
Not added by default
Remarks
—
—
—
Required
Required
Not configured by default.
Required
Not added by default
Remarks
—
—
—
Required