HP 3600 v2 series Configuration Manual page 419

To do...
Create an OSPF area
and enter OSPF area
view
Enable OSPF on the
interface attached to
the specified network
in the area
NOTE:
For more information about OSPF, see
Configuring IS-IS between MCE and PE
Follow these steps to configure IS-IS between MCE and PE:
To do...
Enter system view
Create an IS-IS process for a
VPN instance and enter IS-IS
view
Configure a network entity
title
Redistribute the VPN routes
Configure a filtering policy
to filter the redistributed
routes
Return to system view
Enter interface view
Enable the IS-IS process on
the interface
NOTE:
For more information about IS-IS, see
Configuring eBGP between MCE and PE
Follow these steps to configure eBGP between MCE and PE:
Use the command...
area area-id
network ip-address wildcard-mask
Layer 3—IP Routing Configuration Guide
Use the command...
system-view
isis [ process-id ] vpn-instance
vpn-instance-name
network-entity net
import-route { isis [ process-id ] | ospf
[ process-id ] | rip [ process-id ] | bgp
[ allow-ibgp ] | direct | static } [ cost cost
| cost-type { external | internal } |
[ level-1 | level-1-2 | level-2 ] |
route-policy route-policy-name | tag
tag ] *
filter-policy { acl-number | ip-prefix
ip-prefix-name | route-policy
route-policy-name } export [ isis
process-id | ospf process-id | rip
process-id | bgp | direct | static ]
quit
interface interface-type interface-number
isis enable [ process-id ]
Layer 3—IP Routing Configuration Guide
407
Remarks
Required
By default, no OSPF area is created.
Required
By default, an interface neither belongs to
any area nor runs OSPF.
.
Remarks
—
Required
Required
Not configured by default.
Optional
By default, IS-IS does not
redistribute routes of any other
routing protocol.
If you do not specify the route level
in the command, the command will
redistribute routes to the level-2
routing table by default.
Optional
By default, IS-IS does not filter
redistributed routes.
—
—
Required
Disabled by default.
.