Bgp And Igp Synchronization Configuration - HP 3600 v2 series Configuration Manual

Network
i 2.2.2.2/32
*>i 3.1.1.0/24
*>i 8.1.1.0/24
* i 9.1.1.0/24
The output shows that the route 8.1.1.0 becomes valid with the next hop as Switch A.
Verification.
5.
# Ping 8.1.1.1 on Switch C.
[SwitchC] ping 8.1.1.1
PING 8.1.1.1: 56
Reply from 8.1.1.1: bytes=56 Sequence=1 ttl=254 time=2 ms
Reply from 8.1.1.1: bytes=56 Sequence=2 ttl=254 time=2 ms
Reply from 8.1.1.1: bytes=56 Sequence=3 ttl=254 time=2 ms
Reply from 8.1.1.1: bytes=56 Sequence=4 ttl=254 time=2 ms
Reply from 8.1.1.1: bytes=56 Sequence=5 ttl=254 time=2 ms
--- 8.1.1.1 ping statistics ---
5 packet(s) transmitted
5 packet(s) received
0.00% packet loss
round-trip min/avg/max = 2/2/2 ms

BGP and IGP synchronization configuration

Network requirements
As shown in
belong to AS 65009. AS 65008 and AS 65009 are connected through Switch A and Switch B. Switch
A must be able to access network 9.1.2.0/24 in AS 65009, and Switch C must access network 8.1.1.0/24
in AS 65008.
Figure 91 Network diagram
Configuration procedure
Configure IP addresses for interfaces. (Details not shown)
1.
Configure OSPF.
2.
Enable OSPF in AS 65009, so that Switch B can obtain the route to 9.1.2.0/24.
# Configure Switch B.
Origin : i - IGP, e - EGP, ? - incomplete
NextHop
2.2.2.2
2.2.2.2
3.1.1.2
2.2.2.2
data bytes, press CTRL_C to break
Figure 91, all devices of company A belong to AS 65008, and all devices of company B
MED LocPrf
0 100
0 100
0 100
0 100
236
PrefVal Path/Ogn
0 ?
0 ?
0 65008i
0 ?