Ospf Configuration; Introduction To Ospf; Basic Concepts - HP 3600 v2 series Configuration Manual

OSPF configuration

Open Shortest Path First (OSPF) is a link state interior gateway protocol developed by the OSPF working
group of the Internet Engineering Task Force (IETF). Now, OSPF version 2 (RFC 2328) is used.
NOTE:
Unless otherwise noted, OSPF refers to OSPFv2 throughout this document.
•
The term
•
• The 3600 v2 SI Switch Series does not support OSPF.

Introduction to OSPF

OSPF has the following features:
Wide scope—Supports various network sizes and up to several hundred routers in an OSPF routing
•
domain
Fast convergence—Transmits routing updates instantly upon network topology changes
•
Loop-free—Computes routes with the shortest path first (SPF) algorithm to avoid routing loops
•
• Area-based network partition—Splits an AS into different areas to facilitate management. In
addition, routing information transmitted between areas is summarized to reduce traffic and routing
table sizes.
Equal-cost multi-path (ECMP) routing—Supports multiple equal-cost routes to a destination
•
Routing hierarchy—Supports a four-level routing hierarchy that prioritizes routes into intra-area,
•
inter-area, external Type- 1 , and external Type-2 routes
Authentication—Supports interface-based packet authentication to ensure the security of packet
•
exchange
Support for multicast—Multicasts protocol packets on some types of links
•

Basic concepts

Autonomous System
An Autonomous System (AS) comprises a group of routers that run the same routing protocol.
OSPF route computation
OSPF computes routes in an area as follows:
Based on the network topology around itself, each router generates Link State Advertisements (LSAs)
•
and sends them to other routers in update packets.
• Each OSPF router collects LSAs from other routers to compose a link state database (LSDB). An LSA
describes the network topology around a router, and the LSDB describes the entire network
topology of the AS.
Each router transforms the LSDB in the area to a weighted directed graph, which is the topology of
•
the entire network. All the routers of the area have the same graph.
router
in this document refers to both routers and Layer 3 switches.
55