Specification; General Specification - Mitsubishi A1SJ61BT11 User Manual

3 SPECIFICATION

3. Specification

3.1 General Specification

The general specification is shown in Table 3.1.
Item
Ambient operating
temperature
Ambient storage
temperature
Ambient operating
humidity
Ambient storage humidity
Conforming to
Vibration resistance JIS B 3502,
IEC 61131-2
Shock resistance
Operating ambience
Operating elevation
Installation location
Over voltage category 1
Pollution level 2
1: This indicates the section of the power supply to which the equipment is assumed to be connected between the public
electrical power distribution network and the machinery within the premises. Category II applies to equipment for which
electrical power is supplied from fixed facilities. The surge voltage withstand level for up to the rated voltage of 300V is
2500V.
2: This index indicates the degree to which conductive material is generated in terms of the environment in which the
equipment is used. Pollution level 2 is when only non-conductive pollution occurs. A temporary conductivity caused by
condensation must be expected occasionally.
Table 3.1 General specification
Specifications
0 to 55°C
-20 to 75°C
10 to 90% RH, Non-condensing
10 to 90% RH, Non-condensing
Frequency
10 to 57Hz
Under intermittent
vibration
57 to 150Hz
10 to 57Hz
Under continuous
vibration
57 to 150Hz
Conforming to JIS B 3502, IEC 61131-2
2
(147m/s , 3 times in each of 3 directions X Y Z)
No corrosive gases
2000m (6562 feet) max.
Control panel
3 - 1
Acceleration Amplitude
0.075mm
–
(0.003inch)
2
9.8m/s –
0.035mm
–
(0.001inch)
2
4.9m/s –
II max.
2 max.
MELSEC-A
3
No. of sweeps
10 times each in
X, Y, Z
directions
(for 80 min.)