Data Link Procedure - Mitsubishi A1SJ61BT11 User Manual

7 DATA LINK PROCEDURE

7. Data Link Procedure
7.1 Data Link Procedure
The procedure of performing CC-Link's data link is shown below:
Remote module
Intelligent device module
Set switches on the remote
module/intelligent module.
Station number setting
switch (Section 7.7.1)
Transmission speed setting
switch (Section 7.7.3)
Install the master module and local module to
the base module.
Install the remote module and intelligent device
module to the control board or machine.
Check if the individual master module and
local module operate (Hardware test).
Connect each module with a CC-Link
dedicated cable.
Module type?
Master module
Set switches on the master module (Refer to
Sections 7.3 and 7.7.).
Station number setting switch (Section 7.7.1)
Mode setting switch (Section 7.7.2)
Transmission speed setting switch
(Section 7.7.3)
Condition setting switch (Section 7.7.4)
Check connection status of each module
(Line test).
Programming
Parameter setting program (Chapter 6)
Communication program (Chapter 8)
Start the data link.
Check the set parameters (Parameter
verification test).
7 - 1
MELSEC-A
.........Refer to Section 7.4.
.........Refer to Section 7.5. , 7.6.
Local module
Standby master
module
Set switches on the local module/standby
master module(Refer to Sections 7.3 and 7.7.).
Station number setting switch (Section 7.7.1)
Mode setting switch (Section 7.7.2)
Transmission speed setting switch
(Section 7.7.3)
Condition setting switch (Section 7.7.4)
Programming
Communication program (Chapter 8)
.........Refer to Section 7.8.
.........Refer to Section 7.9.
7