Configure A Basic Mac Acl - NETGEAR MS510TX User Manual

For information about the ACL Wizard, see
page 259.

Configure a Basic MAC ACL

A MAC ACL consists of a set of rules that are matched sequentially against a packet. When a
packet meets the match criteria of a rule, the specified rule action (Permit or Deny) is taken,
and the additional rules are not checked for a match.
Multiple steps are involved in defining a MAC ACL and applying it to the switch:
1. Create the ACL ID.
2. Create a MAC rule.
3. Associate the MAC ACL with one or more interfaces.
You can view or delete MAC ACL configurations in the MAC Binding table (see
Delete MAC ACL Bindings in the MAC Binding Table
Add a MAC ACL

To add a MAC ACL:
1. Connect your computer to the same network as the switch.
You can use a WiFi or wired connection to connect your computer to the network, or
connect directly to a switch that is off-network using an Ethernet cable.
2. Launch a web browser.
3. In the address field of your web browser, enter the IP address of the switch.
If you do not know the IP address of the switch, see
Smart Managed Pro Switches MS510TX and MS510TXPP
Manage Device Security
Use the ACL Wizard to Create a Simple ACL
on page 271.
Access the Switch
264
on
View or
on page 12.