Configure Igmp Snooping Querier - NETGEAR MS510TX User Manual

You can configure and display information about IGMP snooping queriers on the network
and, separately, on VLANs.

Configure IGMP Snooping Querier

You can configure the parameters for IGMP snooping querier. Only a user with read/write
access privileges can change the data on this page.

To configure IGMP snooping querier settings:
1. Connect your computer to the same network as the switch.
You can use a WiFi or wired connection to connect your computer to the network, or
connect directly to a switch that is off-network using an Ethernet cable.
2. Launch a web browser.
3. In the address field of your web browser, enter the IP address of the switch.
If you do not know the IP address of the switch, see
The login window opens.
4. Enter the switch's password in the Password field.
The default password is password.
The System Information page displays.
5. Select Switching> Multicast > IGMP Snooping Querier > Querier Configuration.
The Querier Configuration page displays. The page also shows the VLAN IDs Enabled
for IGMP Snooping Querier section.
6. Next to Querier Admin Mode, select whether the IGMP snooping querier is enabled on the
switch:
• Enable. The switch queries devices on the network for IGMP reports.
• Disable. The switch does not query devices on the network for IGMP reports. This is
the default setting.
7. Configure the following settings:
• Snooping Querier Address. Enter the snooping querier IP address to be used as
the source address in periodic IGMP queries. This address is used when no address
is configured on the VLAN on which a query is being sent.
• Query Interval (secs). Specify the interval in seconds between periodic queries sent
by the snooping querier. The query interval must be a value in the range of 30–1800.
The default value is 125.
8. Click the Apply button.
Your settings are saved.
Smart Managed Pro Switches MS510TX and MS510TXPP
Configure Switching
Access the Switch
139
on page 12.