Configure Stp Settings - NETGEAR MS510TX User Manual

Note: For two bridges to be in the same region, the force version must be
802.1s and their configuration names, digest keys, and revision levels
must match. For additional information about regions and their effect
on network topology, refer to the IEEE 802.1Q standard.
From the Switching > STP > Advanced menu, you can access pages that are described in
the following sections:
•

Configure STP Settings

• Configure CST Settings
• Configure CST Port Settings
• View the CST Port Status
• View Rapid STP Information
• Manage MST Settings
• Configure MST Port Settings
• View STP Statistics
Configure STP Settings
The STP Configuration page contains fields for enabling STP on the switch.

To configure STP settings:
1. Connect your computer to the same network as the switch.
You can use a WiFi or wired connection to connect your computer to the network, or
connect directly to a switch that is off-network using an Ethernet cable.
2. Launch a web browser.
3. In the address field of your web browser, enter the IP address of the switch.
If you do not know the IP address of the switch, see
The login window opens.
4. Enter the switch's password in the Password field.
The default password is password.
The System Information page displays.
5. Select Switching > STP > Basic > STP Configuration.
Smart Managed Pro Switches MS510TX and MS510TXPP
on page 116
on page 118
on page 120
on page 121
on page 123
on page 124
on page 126
on page 129
Configure Switching
Access the Switch
116
on page 12.