Configure Ipv6 Vlan Interface Settings - NETGEAR MS510TX User Manual

The following table describes the nonconfigurable data that is displayed.
Table 49. IPv6 Route Table information
Field
Number of Routes
IPv6 Prefix
Prefix Length
Protocol
Next Hop Interface
Next Hop IP Address
Preference

Configure IPv6 VLAN Interface Settings


Configure IPv6 VLAN interface settings:
1. Connect your computer to the same network as the switch.
You can use a WiFi or wired connection to connect your computer to the network, or
connect directly to a switch that is off-network using an Ethernet cable.
2. Launch a web browser.
3. In the address field of your web browser, enter the IP address of the switch.
If you do not know the IP address of the switch, see
The login window opens.
4. Enter the switch's password in the Password field.
The default password is password.
The System Information page displays.
5. Select Routing> IPv6 > Advanced > VLAN Configuration.
Smart Managed Pro Switches MS510TX and MS510TXPP
Description
The total number of active routes in the route table.
The network prefix for the active route.
The prefix length for the active route.
The type of protocol for the active route:
• Static. The route was manually defined.
• ND (Neighbor Discovery). The route was discovered through the ND
protocol.
• Connected. The route was derived from a manually configured IPv6
address.
The interface over which the route is active. For a rejected route, the next
hop would be a Null0 interface.
The next hop IPv6 address for the active route.
The route preference of the configured route.
Configure Routing
Access the Switch
176
on page 12.