Configure Ipv6; Configure Ipv6 Global Settings - NETGEAR MS510TX User Manual

Configure IPv6

IPv6 is supported only on VLAN interfaces, not on physical ports.
From the Routing > IPv6 > Advanced menu, you can access pages that are described in
the following sections:
•

Configure IPv6 Global Settings

• Add a Static IPv6 Route
• View the IPv6 Route Table
• Configure IPv6 VLAN Interface Settings
• Add an IPv6 Global Address to an IPv6 VLAN
• Add an IPv6 Prefix for Advertisement on an IPv6 VLAN
• View IPv6 Statistics for an Interface
• View or Clear the IPv6 Neighbor Table
Configure IPv6 Global Settings
You can configure IPv6 routing parameters for the switch, as opposed to for an interface.

To configure IPv6 global settings:
1. Connect your computer to the same network as the switch.
You can use a WiFi or wired connection to connect your computer to the network, or
connect directly to a switch that is off-network using an Ethernet cable.
2. Launch a web browser.
3. In the address field of your web browser, enter the IP address of the switch.
If you do not know the IP address of the switch, see
The login window opens.
4. Enter the switch's password in the Password field.
The default password is password.
The System Information page displays.
5. Select Routing> IPv6 > Basic > Global Configuration.
The IPv6 Global Configuration page displays.
6. Next to IPv6 Unicast Routing, select the Enable radio button to globally enable IPv6 unicast
routing.
By default, the Disable radio button is selected.
7. In the IPv6 Hop Limit field, enter a value for the unicast hop count used in IPv6 packets
originated by the node.
Smart Managed Pro Switches MS510TX and MS510TXPP
on page 171
on page 172
on page 175
on page 184
Configure Routing
on page 176
on page 178
on page 181
on page 186
Access the Switch
171
on page 12.