NETGEAR MS510TX User Manual page 43

The following table displays DNS Server Configuration information.
Table 10. DNS Server Configuration information
Field
ID
Preference
Configure and View Host Name-to-IP Address Information
Use this page to manually map host names to IP addresses or to view dynamic host
mappings.
Add a Static Entry to the Dynamic Host Mapping Table

To add a static entry to the local dynamic host mapping table:
1. Connect your computer to the same network as the switch.
You can use a WiFi or wired connection to connect your computer to the network, or
connect directly to a switch that is off-network using an Ethernet cable.
2. Launch a web browser.
3. In the address field of your web browser, enter the IP address of the switch.
If you do not know the IP address of the switch, see
The login window opens.
4. Enter the switch's password in the Password field.
The default password is password.
The System Information page displays.
5. Select System > Management > DNS > Host Configuration.
The DNS Host Configuration page displays.
6. In the Host Name (1 to 158 characters) field, specify the static host name to add.
Its length cannot exceed 158 characters and it is a required field.
7. In the IPv4/IPv6 Address field, enter the IP address to associate with the host name.
8. Click the Add button.
The entry displays in the list on the page.
Smart Managed Pro Switches MS510TX and MS510TXPP
Description
The identification of the DNS Server.
Shows the preference of the DNS server. The preferences are
determined by the order in which they were entered.
Configure System Information
Access the Switch
43
on page 12.