Configure Mld Snooping For A Vlan - NETGEAR MS510TX User Manual

6. Select the MLD Snooping Admin Mode Enable radio button.
By default, the Disable radio button is selected.
7. Click the Apply button.
Your settings are saved.
The VLAN IDs Enabled For MLD Snooping section displays the VLAN IDs, if any, for
which MLD snooping is enabled.

Configure MLD Snooping for a VLAN

When you enable MLD snooping globally (see
on page 142), you can enable MLD snooping on a per-VLAN basis.

To configure MLD snooping for a VLAN:
1. Connect your computer to the same network as the switch.
You can use a WiFi or wired connection to connect your computer to the network, or
connect directly to a switch that is off-network using an Ethernet cable.
2. Launch a web browser.
3. In the address field of your web browser, enter the IP address of the switch.
If you do not know the IP address of the switch, see
The login window opens.
4. Enter the switch's password in the Password field.
The default password is password.
The System Information page displays.
5. Select Switching> Multicast > MLD Snooping > MLD VLAN Configuration.
The MLD VLAN Configuration page displays.
6. From the VLAN ID menu, select the VLAN ID.
7. From the Admin Mode menu, select Enable.
8. From the Fast Leave Admin Mode menu, select to enable or disable the MLD snooping
Fast Leave mode.
Enabling Fast Leave mode lets the switch immediately remove the Layer 2 LAN
interfaces from its forwarding table entry upon receiving an MLD Done message for that
multicast group without first sending MAC-based general queries to the interface.
We recommend that you enable Fast Leave admin mode only on VLANs for which only
one host is connected to a Layer 2 LAN port. This mode prevents the inadvertent
dropping of the other hosts that are connected to the same Layer 2 LAN port but are
configured to receive multicast traffic. Also, fast leave processing is supported only with
MLD version 1 hosts.
Smart Managed Pro Switches MS510TX and MS510TXPP
Configure Switching
Configure the Global MLD Snooping Settings
Access the Switch
143
on page 12.