70
en | Maintenance
15
Maintenance
This chapter contains information about the following points:
–
–
–
–
–
–
–
–
15.1
Menu overview
Maintenance
15.2
Changing language display
Notice!
The fastest way to change the language display is via a shortcut; see also Changing language
display, page 31.
There are two ways of selecting a different language display:
–
–
Notice!
After the system starts up following a power cut or battery failure, the default language
defined in the FSP-5000-RPS programming software is set again.
Making a selection via the menu
1.
2.
3.
15.3
Activate Outputs
1.
2.
3.
4.
2017.09 | 7.0 | F.01U.258.929
Walktest: see Maintenance – walktest, page 73
Changing language display, page 70
Activate Outputs, page 70
Activate Transmission Device, page 71
Detector removal, page 71
Change device on V.24 Interface, page 71
History Log: see Maintenance – history log, page 77
Bypassing/Un-bypassing buzzer, page 72
-> Walktest
Activate outputs
Remove detector
Change device at V.24
interface
Using the menu
Entering a shortcut; see Changing language display, page 31.
In the start menu, select Maintenance
Change language
A list of the languages which can be selected is displayed.
Select the language you require.
The displays are displayed in the selected language.
In the start menu, select Maintenance
Activate outputs
Various element categories are displayed.
Select a category or Select by number and enter the number of the element into the
search screen; see also Search Function/Element, page 29
Select the required list fields. The list fields are marked.
Change language
Activate transmission device
History log
Bypass buzzer
User Guide
Panel Controller
Bosch Sicherheitssysteme GmbH