Maintenance; Walktest - Bosch MPC-xxxx-C Series User Manual

14 en | All functions at a glance
–
–
–
–
–
VAS
Information on all connected electro-acoustic systems that are used for voice evacuation
systems.
3.4

Maintenance

Maintenance
3.4.1

Walktest

Start / End walktest
Elements for the walktest are selected in this submenu. The following possibilities are offered
for selection:
–
–
–
–
–
–
–
–
2017.09 | 7.0 | F.01U.258.929
Information concerning the accessibility of all interfaces and nodes within the system
network.
Ethernet ports
Information concerning various parameters and the status of the two Ethernet interfaces
available at the panel controller.
Send ping command
Sending of a ping command to a specific IP address to check the availability of other
nodes in the network.
Consistency check
The check performed determines whether the Ethernet configuration from FSP-5000-RPS
corresponds to the configuration entered at the panel controller. In the event of
discrepancies, a fault message is displayed.
Ethernet redundancy
Information concerning the type of redundancy configuration (RSTP or dual-homing). In
the case of redundancy via RSTP, the RSTP parameters of the RSTP panel (local bridge)
and those of the root bridge are displayed.
Remote services
Information concerning parameters and status of Remote Services. Connect the panel
manually to the Remote Portal server (the panel automatically tries to connect to the
server every 15 minutes).
-> Walktest
Activate outputs
Remove detector
Change device at V.24
interface
Select by number:
Display of a list of all elements:
Search for an element in a list by entering the number.
Walktest group
Loop
Logical zone
Elements
Transmission device
Control element
More...
– DACT
Change language
Activate transmission device
History log
Bypass buzzer
User Guide
Panel Controller
Bosch Sicherheitssysteme GmbH