Signals; Resetting Malfunction Message - Bosch MPC-xxxx-C Series User Manual

54 en | Fault message
Notice!
The information displayed is entered in the FSP-5000-RPS programming software.
The following information is displayed:
–
–
–
–
–
–
Select OK to return to the list of all fault messages. Reset, see Resetting malfunction message,
page 54.
Block, see Isolating an element, page 55.
11.2.8

Signals

Optical signals
An internal buzzer sounds on the panel and the "fault" signal light turns yellow.
Depending on the type of fault, an additional yellow signal light lights up (see also Display
elements, page 20):
–
–
–
Acoustic signal
An internal signal tone sounds on the system.
To temporarily switch off the internal buzzer:
Press the "Signal tone off" key.
The internal signal tone is switched off.
11.3

Resetting malfunction message

Caution!
If a message does not have to be reset, it is removed from the display as soon as the fault has
!
been rectified.
Depending on the configuration, three different variants are offered for resetting; see Resetting
alarm message, page 49.
There are two ways to reset a fault message:
–
–
If a list field is marked with an "R", the process of resetting is not yet complete for this
element.
TEXT
If an element cannot be reset, it will continue to be displayed in the list.
2017.09 | 7.0 | F.01U.258.929
Element category
Message type
Date and time of the message
Physical and logical addressing of the element
Only for LSN detectors: specification of the detector type
Action text (depending on the configuration)
Fault System
Fault Transmission Device
Fault Signals
Select Reset in the message display or
Select the fault message and then press Reset in the detailed view
The selected element/element group is reset.
R
User Guide
Panel Controller
Bosch Sicherheitssysteme GmbH