Overview - Bosch MPC-xxxx-C Series User Manual

88 en | Configuration
1.
2.
3.
4.
5.
6.
7.
Notice!
Only change the System ID if you want to reuse an already existing System ID.
See also
–
–
19.8

Overview

To display important information on the valid configuration of the system:
1.
2.
2017.09 | 7.0 | F.01U.258.929
Connect the secure network gateway for Remote Services with the panel and the internet
access point.
Go to Configuration - Network services - Ethernet - IP settings: Enter the IP address of
the panel. Check the Use Ethernet settings box. For details please see IP settings, page
36.
Restart the panel by removing the power supply or using the reset button
Go to Configuration - Network services - Change date / time . Enter the current date.
For details please see Change Date / Time, page 89.
Go to Configuration - Network services - Remote services - Remote ID: Enter the
Remote ID (10-digit) via the alphanumeric keys on the keypad. To delete a Remote ID
entry choose Clear. Confirm with OK and return to the Network services screen. To leave
the screen without saving changes choose Cancel.
The System ID is assigned to the panel by the Remote Portal. Normally it is not necessary
to change it. In case you need to change it, choose Change System ID. Enter the System
ID (9-digit) via the alphanumeric keys on the keypad.
Confirm with OK and return to the Remote services screen. To leave the screen without
saving changes choose Cancel.
IP settings, page 36
Change Date / Time, page 89
In the start menu, select Configuration
Overview
The following information is displayed:
– Configuration and additional information on this
– Date
– Configuration version (Config. version)
– Number
– Name
– IP address
– Scope
– Country
– Time zone
– Menu name
User Guide
Panel Controller
Bosch Sicherheitssysteme GmbH