16
en | All functions at a glance
Filter
User commands
Walktest
3.4.7
Change device on V.24 Interface
Assigning a different device to the V.24 interface (Change device at V.24 interface).
3.5
Configuration
Configuration
Set input / output groups
–
–
–
–
Set groups
–
–
–
–
Detector sensitivity
Change the sensitivity of individual detectors or zones. Two selection options are available: a
default sensitivity and an alternative sensitivity assigned in the FSP-5000-RPS programming
software.
Operator
If the same password is used per access level, the following options are offered:
–
If every user has a different password, the following options are offered:
–
–
Rename elements
Change the description of the elements.
Overview
Information on valid system configuration.
–
2017.09 | 7.0 | F.01U.258.929
-> Set input / output
groups
Detector sensitivity
Rename elements
Network services
Input group or Output group
Displaying the assigned elements.
Add or delete elements.
Rename group names.
Bypass group, isolate group or walktest group
Displaying the assigned elements.
Add or delete elements.
Rename walktest, bypass and isolate groups.
Change universal password
The same password can be configured for each access level in the FSP-5000-RPS
programming software. The password for access levels two to four can be changed.
Change operator data
Change a user's password.
Set default password
Reset an operator's password to his/her previous password.
Ethernet
Change and activate network settings (IP settings, Ethernet redundancy). Changes take
effect after restarting the panel.
Data, filtered by...
Selected function fields, such as Acknowledge or Reset.
Elements switched to walktest mode
Set groups
Operator
Overview
About ...
User Guide
Panel Controller
Bosch Sicherheitssysteme GmbH