Alarm Counters - Bosch MPC-xxxx-C Series User Manual

92 en | Further functions
During the fire drill, fire alarms, fault messages and supervisory alarms are displayed.
To switch between the fire drill display and the message display in question, select Return to
message screen or Return to drill screen on the status bar.
If an alarm or a fault/supervisory alarm is sounded during a fire drill, the panel controller
reacts as described in the table below:
The drill signaling devices are
switched off.
The drill is automatically
terminated.
Display switches to
Fire drill after event ends
A new function cannot be selected until the fault/supervisory alarm and/or the fire drill have
been completed.
20.7

Alarm Counters

Show Lifetime Event Counters
During the lifetime of the panel, the following alarm messages are counted:
–
–
–
To display the number of alarm messages which have been counted so far:
1.
2.
The figure after the message type shows the number of messages counted so far.
Reset counters
You can reset the alarm counter for individual alarm types to 0.
To reset alarm counters
1.
2.
3.
4.
5.
Notice!
In order to reset alarm counters, you need authorization level 4.
2017.09 | 7.0 | F.01U.258.929
External alarm: all fire messages
Internal alarm: all alarm messages that the panel receives in day mode
Walktest alarm: all messages from detectors switched to walktest
In the start menu, select Further functions
Alarm counters
In the start menu, select Further functions
Alarm counters
Mark the alarm counter you require (e.g. external alarm)
Select Reset
Confirm the message "Attention: Counter will be reset" with OK to reset the alarm
counter to 0 or select Cancel to cancel the operation.
Fire alarm
Yes
Yes
Alarm indication
Must be restarted
manually
User Guide
Panel Controller
Fault/ supervisory alarm
No
No
Fault indication
Continue
Bosch Sicherheitssysteme GmbH