Table of Contents
Advertisement
Dell Networking OS
To initially configure the Dell Networking operating system (OS), use the following sections.
NOTE: This chapter applies ONLY if you already have the Dell Networking OS installed on your
system from the factory. If you are installing a third-party OS, refer to your third-party OS
documentation.
NOTE: For complete installation and configuration information, refer to the following documents at
www.dell.com/support:
•
Dell Networking Installation Guide for the S4048–Open Networking (ON) System.
•
Dell Networking Command Line Reference Guide for the S4048–Open Networking (ON)
System.
•
Dell Networking Configuration Guide for the S4048–Open Networking (ON) System.
•
Dell Networking Release Notes for the S4048–Open Networking (ON) System.
Enter the Initial Configuration Information
To set up the switch, assign an IP address and other configuration information necessary for the switch to
communicate with the local routers and the Internet. The minimal configuration provided here does not
cover most of the features; it simply allows you to perform other configuration tasks using a Telnet
connection from your management network.
NOTE: To configure other features and interfaces, refer to the Dell Networking OS Configuration
Guide for the S4048 System.
IP Settings
To set up the switch, get the following information from your network administrator:
•
Switch IP address
•
Subnet mask (IP netmask)
•
Default gateway (router)
•
Enable secret password
•
Enable password
•
Telnet password
16
3
Dell Networking OS
Hide quick links:
Advertisement
Table of Contents
