Cn Sig Connector - Panasonic minas a series Operating Manual

System configutration and wiring
CN SIG Connector (For Encoder)
Wiring Instructions
Power
Motor
Encoder
Connector
20 cm
Cannon plug
max.
20 cm
Encoder cable
3.6V+
3.6VG
SD
SD
+ 5V
0V
Pin 3,
15 or J
FG
(J)
Connectors
(canon plugs) on
the encoder
ID MODE SET
IM SP G
SER
IN
L 1
SER
OUT
L 2
L 3 I/F
r
t
P
B 1
B 2
SIG
min. 30 cm
U
V
W
max. 20 cm
Connecting cable
max.
Connecting cable
BATT+
BATT-
RX/TX
RX/TX
+ 5V
0V
+ 5V
0V
20
FG
CN SIG
connectors
on the driver
The cable length between the driver and motor
should be max. 20 m. If you use a longer cable,
contact the dealer or sales agent.
Separate these wiring min. 30 cm from the
main circuit wires. Don't lay these wires
in the same duct of the mains or bundle
with them.
Two types of encoder wire exit: One is
"Lead wire + connector" and other is Can-
non plug type(depending on the motor
model).
When you prepare your own connecting
cables see the "Optional Parts" for
connectors, and
1) Follow the wiring diagram and use the
2) Wire material: 0.18 mm2 (AWG24) or
above, shielded twist-paired wire with an
enough bending durability,
3) Signal/power paired wires should be of
a twist-paired type.
4) Shield:
• The shield at the driver side should be
connected to Pin 20 (FG) of CN SIG
Connector.
• The shield at the motor side should be
connected to:
Pin 3 (for AMP connector of 9 pins type)
Pin 15 (for AMP connector of 15 pins type)
J-pin (for canon plug connector)
5) If the cable is longer than 10 m, the encoder
power line (+5V and 0V) should be dual per
the figure shown left.
6) Other terminals should be left uncon-
nected.
- 24 -