Siemens SIPROTEC Manual page 649

Optical attenuators/fibre-optic cables
Designation
1 set of optical attenuators (2 pcs)
Fibre-optic cables
1)
Fibre-optic cables with different connectors, in different lengths and designs. More information will be avail-
able from your local Siemens sales representative.
Isolating Transformers
Isolating transformers are needed on copper lines if the longitudinal voltage induced in the pilot wires can result
in more than 60 % of the test voltage at the communication converter (i.e. 3 kV for CC-CU). They are connected
between the communication converter and the communication line.
Name
Isolation transformer, test voltage 20 kV
GPS
Name
GPS receiver with antenna and cable
Power supply
Time synchronization converter
Bus cable for 7SD52, for GPS sync.
Voltage Transformer Miniature Circuit Breaker
Nominal Values
Thermal 1.6 A; magnetic 6 A
External Converters
Optical interfaces for Profibus and DNP 3.0 are not possible with surface mounting housings. Please order in
this case a device with the appropriate electrical RS485 interface, and the additional OLM converters listed
below . Note: The OLM converter 6GK1502-3CB10 requires an operating voltage of DC 24 V. If the operating
voltage is > DC 24 V the additional power supply 7XV5810-0BA00 is required.
Interface used
Profibus DP/FMS double ring
DNP 3.0 820 nm
SIPROTEC, 7SD5, Manual
C53000-G1176-C169-5, Release date 02.2011
1)
A.1 Ordering Information and Accessories
Order number
7XV5107–0AA00
6XV8100
Order Number
7XR9516
Order No.
7XV5664-0AA00
7XV5810-0BA00
7XV5656-0BA00
7XV5105-0AA00
Order No.
3RV1611-1AG14
Order device with additional
module/OLM converter
Profibus DP/FMS RS485/
6GK1502-3CB01
DNP 3.0 RS485/ 7XV5650-
0BA00
Appendix
649