Chapter 7 Reduction and Reversing Gear
3. Inspection and Servicing
3. Start engine and run for two minutes to fill system with
fluid.
4. Stop engine and check fluid level. Fluid should be be-
tween "Min" and "Max" lines on dipstick.
Typical Hurth Transmission Shown
(3) Transmission Removal
1. Refer to Removal and Installation, Section 2B-"MIE In-
board) Models" and remove engine and transmission as
instructed.
2. Disconnect wires from neutral safety switch and audio
warning temperature switch.
a - Neutral Safety Switch
b - Audio Warning Temperature Switch
Typical Hurth Transmission Shown
3. Follow instructions "a" or "b":
a. On 530D-TA, 636D-TA, D183 and D219 Engines:
Disconnect seawater hoses from transmission fluid
cooler.
a - Seawater Inlet Hose
b - Seawater Outlet Hose
c - Transmission Fluid Cooler
530D-TA, 636D-TA, D183 and D219 Shown
4LHA Serie: