Appendix 8 Connection Examples With Servo Amplifiers Manufactured By Sanyo Denki Co., Ltd - Mitsubishi Electric AJ65BT-D75P2-S3 User Manual

Hide thumbs Also See for AJ65BT-D75P2-S3:

Appendix 8 Connection examples with servo amplifiers manufactured

by SANYO DENKI Co., Ltd.

Appendix 8.1 Connection example of D75P2 and PYO series (Differential driver) *

*1 Assignment of the pin numbers of the connector of the D75P2 is the same for axis 1 and axis 2.

*2 The upper limit (FLS) and lower limit (RLS) of the D75P2 are used for the zero point return retry function.

Set these inside the limit switches for the servo.

*3 For the connections on the servo amplifier side other than those specified above and the shields of each signal

cable, refer to the manual prepared for the servo amplifier.

*4 Use "Logic selection for pulse output to the drive unit" specified in detailed parameter 1 to match the logic (positive

or negative logic) between the D75P2 and the servo amplifier. The initial setting of D75P2 is a positive logic.

*5 Indicates the distance between the D75P2 and PYO.

Appendix - 23

Chapters