Advertisement
4
INSTALLATION, WIRING AND MAINTENANCE OF THE PRODUCT
4.2.2 Installation/removal of module
[1] Installation (removal) to (from) DIN rail
Installation procedure
This section explains the procedures for installing and removing the D75P2.
(1)
Confirm if all phases of the externally supplied power for the system are switched
off or not.
*If not, switch off all phases.
(2)
Match the DIN rail groove in the module bottom with the top of the DIN rail.
(3)
Press the module against the DIN rail, and fix it there.
DIN rail
(4)
Confirm that the module is fixed to the DIN rail.
[After-work checks]
After installing the module, check the work as in the following list.
Check the module for looseness.
Check the DIN rail for looseness.
Module installation method
4 - 9
MELSEC-A
Module
Advertisement
Chapters
Troubleshooting
