Compatible Devices With Sscnetiii(/H); Servo Driver Vcii Series/Vph Series Manufactured By Ckd Nikki Denso Co., Ltd - Mitsubishi Electric MELSEC iQ-R16MTCPU Programming Manual

5.8

Compatible Devices with SSCNETIII(/H)

Servo driver VCII series/VPH series manufactured by CKD Nikki
Denso Co., Ltd.
The direct drive DISC/iD roll/Servo compass/Linear stage, etc. manufactured by CKD Nikki Denso Co., Ltd. can be
controlled by connecting with the servo driver VC series/VPH series manufactured by the same company using the Motion
CPU and SSCNET(/H).
Contact CKD Nikki Denso overseas sales office for details of VC series/VPH series.
System configuration
The system configuration using VC series/VPH series is shown below.
Motion CPU module
R MTCPU
SSCNETµcable
SSCNETµ(/H)(CN1)
MR-J3BUS M(-A/-B)
SSCNETµ(/H)(CN2)
*1 When the communication type is SSCNET, the R64MTCPU controls a maximum of 16 axes per line.
Parameter setting
To connect VC series/VPH series, set the following in the servo network setting. (Page 64 Servo network setting)
• Set the following for communication type in SSCNET setting.
• When connecting SSCNET/H: "SSCNET/H"
• When connecting SSCNET: "SSCNET"
• Set the amplifier model in amplifier setting to "VC (CKD NIKKI DENSO)" or "VPH (CKD NIKKI DENSO)".
Servo driver
VC´ series/VPH series MR-J4(W)- B/MR-J3(W)- B
Servo driver
VC´ series/VPH series MR-J4(W)- B/MR-J3(W)- B
R64MTCPU: 2 lines (Up to 64 axes (Up to 32 axes/line))
R32MTCPU: 2 lines (Up to 32 axes (Up to 16 axes/line))
R16MTCPU: 1 line (Up to 16 axes)
5 FUNCTIONS USED WITH SSCNET COMMUNICATION
5.8 Compatible Devices with SSCNETIII(/H)
Servo amplifier
Servo amplifier
*1
5
251