Advertisement
4 INSTALLATION, WIRING AND MAINTENANCE OF THE PRODUCT
4.1 Outline of installation, wiring and maintenance
4.1.1 Installation, wiring and maintenance procedures
STEP 1
Preparation
Refer to
section 4.1
STEP 2
Installing the
Refer to
module
section 4.2
STEP 3
Refer to
Connection and
section 4.3
setting as
CC-Link
STEP 4
Refer to
section 4.4
STEP 5
Refer to
section 4.5
Wiring the
drive unit
STEP 6
Refer to
section 4.5
STEP 7
Refer to
Confirming the
section 4.7
installation and
wiring
STEP 8
STEP 9
Refer to
section 4.8
Servicing the
module
STEP 10
Refer to
section 4.8
The outline and procedures for D75P2 installation, wiring and maintenance are shown
below.
Understand the "Handling precautions" and
"Names of each part" of the module (D75P2)
Install the module (D75P2) on the
DIN rail/enclosure surface
Wire the CC-Link dedicated cables to the
module (D75P2).
Set the station number and transmission
speed of the module (D75P2).
Wire the external device connection
connector pins, and assemble the connector.
Connect the cable to the module (D75P2)
Carry out the single module test
Confirm the connection
Operation of the positioning system.
Carry out maintenance
Dispose of the D75P2
The cables used to connect the D75P2 with the drive
*
unit, the D75P2 with the machine system input (each
input/output signal), and the D75P2 with the manual
pulse generator are manufactured by soldering each
signal wire onto the "external device connection
connector" enclosed with the D75P2.
Wire and connect the manufactured cable to D75P2
after reading the precautions for wiring.
Confirm that the D75P2 functions properly
*
with the single module test.
*
Check the connection using the GX Configurator-AP.
*
Carry out maintenance as necessary.
*
When the D75P2 is no longer necessary,
dispose of it with the specified methods.
4 - 2
MELSEC-A
Advertisement
Chapters
Troubleshooting
