Omron NV Series Setup Manual page 63

Preparations for Operation
When Power (5 V) Is Supplied from the PLC (NV3W(-V1) Only)
1 Start the NV-Designer.
2 Set NV-Designer Configuration.
Set NV Configuration from the NV-Designer.
3
Create screens with the NV-Designer.
Connect the PT and PLC using the
4
XW2Z-200T-4 RS-232C Cable.
5 Connect the personal computer and the PT.
Turn ON the power to the PLC.
6
(The PLC will supply 5 V to the PT.)
7 Transfer the project data from the NV-Designer
to the PT (including screen data).
Make settings from the PT's System Menu.
8
9 Transfer the PLC Setup from the CX-Programmer
to the PLC.
(Set the Host Link mode and one stop bit.)
10
Cycle the power supply to the PLC.
11
Start communications between the PT and PLC.
*1
*2
*3
*1 For details, refer to Section 5 Creating and Sav-
*1
ing Projects (Including Screen Data) in the NV-
series Programming Manual (Cat. No. V104).
*2 For details, refer to Section 3 NV-Designer Out-
line and Configuration in the NV-series Pro-
gramming Manual (Cat. No. V104).
*3 For details, refer to Section 6 NV Configuration
in the NV-series Programming Manual (Cat. No.
V104).
Note
(1) The default language for the System Menu is
(2) If the PT is connected to a C-series or CV/
English.
You can use the NV-Designer to set the System
Menu language to Japanese on the Setup 1 Tab
Page of the NV Configuration.
Refer to 5-1-2 System Menu Language for de-
tails.
CVM1-series PLC, keep the PLC in MONITOR
mode. If the PLC is in RUN mode and the PT at-
tempts to write to PLC memory, an error code of
ER01 will be displayed and memory will not be
written.
Section 3-1
43