Omron NV Series Setup Manual page 104

Configuration Settings from the System Menu
Port Communications Settings (COM Port)
84
Touch Panel Operation
Adjustment The value can be set to between 0 and 14. The brightness will
increase if the + Key is touched and decrease if the − Key is touched.
The number and diamond mark show the setting. The standard set-
ting is 14, for which the diamond mark will be all the way to the right.
Returning After completing the setting, touch the ESC Key to return to the previ-
ous screen.
To display the Port Screen, touch "Setting" from the Startup Screen of the
System Menu and then touch "Port" on the Setting Screen. Then touch COM.
Port to display the COM Port Screen. Here you can set the communications
settings for communications with the PLC connected to the PT.
Setting COM Port Communications Conditions (PLC Communications
Conditions)
Accessing Screens
Startup Screen
↓
[Setting]
↓
[Port]
↓
[COM Port]
Bit Rate: PLC Baud Rate
Set the baud rate to use in communicating with the external device (PLC) con-
nected to the PT. The setting will scroll through the following settings as the
function key is presses: 9,600, 19,200, 38,400, 57,600, and 115,200. Set the
baud rate ("bit rate") to the same value as the PLC that is connected.
Format: Transmission Format
Set the transmission format to use in communicating with the external device
(PLC) connected to the PT, including the character length, number of stop
bits, and parity. The setting will scroll through the following settings as the
function key is presses: 7/1/None, 7/1/Odd, 7/1/Even, 8/1/None, 8/1/Odd, and
8/1/Even. Set the same format as the PLC that is connected.
Touch Panel Operation
Returning After completing the setting, touch the ESC Key to return to the previ-
ous screen.
Section 5-1