Omron NV Series Setup Manual page 52

System Versions
Version Upgrade
Procedure Using NV
Ver_UP Tool
Note
32
NV Ver_UP is a special tool to upgrade the firmware version of the PT.
The NV Ver_UP version upgrade tool is installed at the same time as the NV-
Designer.
Click the Start Button at the bottom left of the window or select All Programs
from the menu displayed by pressing the Ctrl Key and the Esc Key, and then
select CX-One - NV-Designer - Tools - NV Ver_UP from the OMRON Menu.
NV Ver_UP Dialog Box
Select NV Firmware Dialog Box
Communication Setting Dialog Box
Upgrading the version will start when the Start Button is clicked.
The NV Ver_UP version upgrade tool will end when the Exit Button is clicked.
(1) Never turn OFF the power supply to the PT while the version is being up-
graded.
(2) Do not unplug the cable between the computer and the NV-series PT.
Otherwise, the PT may not restart.
Section 1-6
Select the firmware (Select
(Firmware) Button) and set
the communications condi-
tions (Communication Setting
Button). The applicable set-
tings dialog box will be dis-
played when either of the
buttons is clicked.
Select the most recent firm-
ware version (i.e., highest ver-
sion number) for the model
that you are using. Click the
OK Button to return to the NV
Ver_UP Dialog Box.
Make the communications
setting, and then click the OK
Button to return to the NV
Ver_UP Dialog Box. These
selections cannot be made for
the NV3W-V1, NV4W or
NV3Q.
For the NV3W, select the
COM port that you are actu-
ally using.