Command Accounting - Cisco Catalyst 2960 series Configuration Manual

Information About Configuring Accounting
Wed Jun 27 04:48:46 2001
The following example shows the information contained in a TACACS+ EXEC accounting record for a Telnet
user:
Wed Jun 27 04:06:53 2001
starttask_id=41
Wed Jun 27 04:07:02 2001
stoptask_id=41

Command Accounting

Command accounting provides information about the EXEC shell commands for a specified privilege level
that are being executed on a network access server. Each command accounting record includes a list of the
commands executed for that privilege level, as well as the date and time each command was executed, and
the user who executed it.
The following example shows the information contained in a TACACS+ command accounting record for
privilege level 1:
Wed Jun 27 03:46:47 2001
stop
Wed Jun 27 03:46:58 2001
stop
<cr>
Wed Jun 27 03:47:03 2001
stop
The following example shows the information contained in a TACACS+ command accounting record for
privilege level 15:
Wed Jun 27 03:47:17 2001
stop
Wed Jun 27 03:47:21 2001
stop
Wed Jun 27 03:47:29 2001
stop
<cr>
The Cisco implementation of RADIUS does not support command accounting.
Note
Consolidated Platform Configuration Guide, Cisco IOS Release 15.2(4)E (Catalyst 2960-X Switches)
1010
Acct-Status-Type = Start
Acct-Authentic = RADIUS
Service-Type = Exec-User
Acct-Session-Id = "00000010"
Acct-Delay-Time = 0
User-Id = "username1"
NAS-Identifier = "172.16.25.15"
NAS-IP-Address = "172.16.25.15"
NAS-Port = 26
User-Name = "username1"
Caller-ID = "10.68.202.158"
Acct-Status-Type = Stop
Acct-Authentic = RADIUS
Service-Type = Exec-User
Acct-Session-Id = "00000010"
Acct-Session-Time = 14
Acct-Delay-Time = 0
User-Id = "username1"
NAS-Identifier = "172.16.25.15"
service=shell
service=shell
task_id=3 service=shell
task_id=4 service=shell
task_id=5 service=shell
task_id=6 service=shell
task_id=7 service=shell
task_id=8 service=shell
172.16.25.15 username1
172.16.25.15 username1
elapsed_time=9
172.16.25.15 username1
priv-lvl=1
172.16.25.15 username1
priv-lvl=1
172.16.25.15 username1
priv-lvl=1
172.16.25.15 username1
priv-lvl=15
172.16.25.15 username1
priv-lvl=15
172.16.25.15 username1
priv-lvl=15 cmd=ip address 10.1.1.1 255.255.255.0
tty26 10.68.202.158
tty26 10.68.202.158
tty3 5622329430/4327528
cmd=show version <cr>
tty3 5622329430/4327528
cmd=show interfaces Ethernet 0
tty3 5622329430/4327528
cmd=show ip route <cr>
tty3 5622329430/4327528
cmd=configure terminal <cr>
tty3 5622329430/4327528
cmd=interface Serial 0 <cr>
tty3 5622329430/4327528