Consolidated Platform Configuration Guide, Cisco Ios Release 15.2(4)E (Catalyst 2960-X Switches - Cisco Catalyst 2960 series Configuration Manual

Command or Action
Step 4
storm-control {broadcast | multicast
| unicast} level {level [level-low] | bps
bps [bps-low] | pps pps [pps-low]}
Example:
Switch(config-if)# storm-control
unicast level 87 65
Step 5 storm-control action {shutdown |
trap}
Example:
Switch(config-if)# storm-control
action trap
Purpose
Configures broadcast, multicast, or unicast storm control. By default, storm control
is disabled.
The keywords have these meanings:
• For level, specifies the rising threshold level for broadcast, multicast, or
unicast traffic as a percentage (up to two decimal places) of the bandwidth.
The port blocks traffic when the rising threshold is reached. The range is
0.00 to 100.00.
• (Optional) For level-low, specifies the falling threshold level as a percentage
(up to two decimal places) of the bandwidth. This value must be less than
or equal to the rising suppression value. The port forwards traffic when
traffic drops below this level. If you do not configure a falling suppression
level, it is set to the rising suppression level. The range is 0.00 to 100.00.
If you set the threshold to the maximum value (100 percent), no limit is
placed on the traffic. If you set the threshold to 0.0, all broadcast, multicast,
and unicast traffic on that port is blocked.
• For bps bps, specifies the rising threshold level for broadcast, multicast, or
unicast traffic in bits per second (up to one decimal place). The port blocks
traffic when the rising threshold is reached. The range is 0.0 to
10000000000.0.
• (Optional) For bps-low, specifies the falling threshold level in bits per second
(up to one decimal place). It can be less than or equal to the rising threshold
level. The port forwards traffic when traffic drops below this level. The
range is 0.0 to 10000000000.0.
• For pps pps, specifies the rising threshold level for broadcast, multicast, or
unicast traffic in packets per second (up to one decimal place). The port
blocks traffic when the rising threshold is reached. The range is 0.0 to
10000000000.0.
• (Optional) For pps-low, specifies the falling threshold level in packets per
second (up to one decimal place). It can be less than or equal to the rising
threshold level. The port forwards traffic when traffic drops below this level.
The range is 0.0 to 10000000000.0.
For BPS and PPS settings, you can use metric suffixes such as k, m, and g for
large number thresholds.
Specifies the action to be taken when a storm is detected. The default is to filter
out the traffic and not to send traps.
• Select the shutdown keyword to error-disable the port during a storm.
• Select the trap keyword to generate an SNMP trap when a storm is detected.

Consolidated Platform Configuration Guide, Cisco IOS Release 15.2(4)E (Catalyst 2960-X Switches)

How to Configure Port Security
1497