Consolidated Platform Configuration Guide, Cisco Ios Release 15.2(4)E (Catalyst 2960-X Switches - Cisco Catalyst 2960 series Configuration Manual

How to Configure NetFlow Lite
Command or Action
Step 2
flow exporter name
Example:
Switch(config)# flow exporter ExportTest
Step 3 description string
Example:
Switch(config-flow-exporter)# description
ExportV9
Step 4 destination {ipv4-address} [ vrf vrf-name]
Example:
Switch(config-flow-exporter)# destination
192.0.2.1 (IPv4 destination)
Step 5 dscp value
Example:
Switch(config-flow-exporter)# dscp 0
Step 6 source { source type }
Example:
Switch(config-flow-exporter)# source
gigabitEthernet1/0/1
Step 7 transport udp number
Example:
Switch(config-flow-exporter)# transport udp
200
Step 8 ttl seconds
Example:
Switch(config-flow-exporter)# ttl 210

Consolidated Platform Configuration Guide, Cisco IOS Release 15.2(4)E (Catalyst 2960-X Switches)

524
Purpose
Creates a flow exporter and enters flow exporter
configuration mode.
(Optional) Describes this flow record as a maximum
63-character string.
Sets the IPv4 destination address or hostname for this
exporter.
(Optional) Specifies the differentiated services codepoint
value. The range is from 0 to 63. The default is 0.
(Optional) Specifies the interface to use to reach the
NetFlow collector at the configured destination. The
following interfaces can be configured as source:
(Optional) Specifies the UDP port to use to reach the
NetFlow collector. The range is from 1 to 65536
(Optional) Configures the time-to-live (TTL) value for
datagrams sent by the exporter. The range is from 1 to 255
seconds. The default is 255.