Consolidated Platform Configuration Guide, Cisco Ios Release 15.2(4)E (Catalyst 2960-X Switches - Cisco Catalyst 2960 series Configuration Manual

Information about RADIUS
Cause Code
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
60
61
62
63
64

Consolidated Platform Configuration Guide, Cisco IOS Release 15.2(4)E (Catalyst 2960-X Switches)

920
Value
Timeout-PPP-LCP
Failed-PPP-LCP-Negotiation
Failed-PPP-PAP-Auth-Fail
Failed-PPP-CHAP-Auth
Failed-PPP-Remote-Auth
PPP-Remote-Terminate
PPP-Closed-Event
NCP-Closed-PPP
MP-Error-PPP
PPP-Maximum-Channels
Tables-Full
Resources-Full
Invalid-IP-Address
Bad-Hostname
Bad-Port
Reset-TCP
TCP-Connection-Refused
Timeout-TCP
Foreign-Host-Close-TCP
TCP-Network-Unreachable
Description
PPP LCP negotiation timed out.
Note Codes 40 through 49 apply to PPP
sessions.
PPP LCP negotiation failed.
PPP PAP authentication failed.
PPP CHAP authentication failed.
PPP remote authentication failed.
PPP received a Terminate Request from
remote end.
Upper layer requested that the session be
closed.
PPP session closed because there were no
NCPs open.
PPP session closed because of an MP error.
PPP session closed because maximum
channels were reached.
Disconnect due to full terminal server
tables.
Disconnect due to full internal resources.
IP address is not valid for Telnet host.
Hostname cannot be validated.
Port number is invalid or missing.
TCP connection has been reset.
Codes 60 through 67 apply to
Note
Telnet or raw TCP sessions.
TCP connection has been refused by the
host.
TCP connection has timed out.
TCP connection has been closed.
TCP network is unreachable.