X User Distribution Configuration Guidelines - Cisco Catalyst 2960 series Configuration Manual

Information About 802.1x Port-Based Authentication

802.1x User Distribution Configuration Guidelines

• Confirm that at least one VLAN is mapped to the VLAN group.
• You can map more than one VLAN to a VLAN group.
• You can modify the VLAN group by adding or deleting a VLAN.
• When you clear an existing VLAN from the VLAN group name, none of the authenticated ports in the
VLAN are cleared, but the mappings are removed from the existing VLAN group.
• If you clear the last VLAN from the VLAN group name, the VLAN group is cleared.
• You can clear a VLAN group even when the active VLANs are mapped to the group. When you clear
a VLAN group, none of the ports or users that are in the authenticated state in any VLAN within the
group are cleared, but the VLAN mappings to the VLAN group are cleared.
IEEE 802.1x Authentication with Voice VLAN Ports
A voice VLAN port is a special access port associated with two VLAN identifiers:
• VVID to carry voice traffic to and from the IP phone. The VVID is used to configure the IP phone
connected to the port.
• PVID to carry the data traffic to and from the workstation connected to the switch through the IP phone.
The PVID is the native VLAN of the port.
The IP phone uses the VVID for its voice traffic, regardless of the authorization state of the port. This allows
the phone to work independently of IEEE 802.1x authentication.
In single-host mode, only the IP phone is allowed on the voice VLAN. In multiple-hosts mode, additional
clients can send traffic on the voice VLAN after a supplicant is authenticated on the PVID. When multiple-hosts
mode is enabled, the supplicant authentication affects both the PVID and the VVID.
A voice VLAN port becomes active when there is a link, and the device MAC address appears after the first
CDP message from the IP phone. Cisco IP phones do not relay CDP messages from other devices. As a result,
if several IP phones are connected in series, the switch recognizes only the one directly connected to it. When
IEEE 802.1x authentication is enabled on a voice VLAN port, the switch drops packets from unrecognized
IP phones more than one hop away.
When IEEE 802.1x authentication is enabled on a switch port, you can configure an access port VLAN that
is also a voice VLAN.
When IP phones are connected to an 802.1x-enabled switch port that is in single host mode, the switch grants
the phones network access without authenticating them. We recommend that you use multidomain authentication
(MDA) on the port to authenticate both a data device and a voice device, such as an IP phone
If you enable IEEE 802.1x authentication on an access port on which a voice VLAN is configured and to
Note
which a Cisco IP Phone is connected, the Cisco IP phone loses connectivity to the switch for up to 30
seconds.
Consolidated Platform Configuration Guide, Cisco IOS Release 15.2(4)E (Catalyst 2960-X Switches)
1344